Engine alignment query
#1
Engine alignment query
Hi guys, just fitted my phase 1 block to my phase 2 car however noticed that some of the bolts no longer line up to the transmission, the two bolts at the base do and the bolts at the top do but centre ones dont line up, will this be a major problem running the car like this
#2
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
no the phase 1 block only has the four..
as long as you put the two dowels in..
you should have an issue at the starter motor area.. there is now no stud for the 17mm nut to go on at the bottom of the starter motor iirc.
You can thread it and fit a bolt etc..
Simon
as long as you put the two dowels in..
you should have an issue at the starter motor area.. there is now no stud for the 17mm nut to go on at the bottom of the starter motor iirc.
You can thread it and fit a bolt etc..
Simon
#3
Thanks mate, this would mean an engine out then to sort a new thread i presume dont really want to go through that all over again
Does anyone have a working phase 2 block/engine that i can throw in my00 uk turbo
Does anyone have a working phase 2 block/engine that i can throw in my00 uk turbo
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM