Hi guys, i`m new to this. so go easy on me.
been looking at adding a couple of gauges to me A pillar (boost and oil temp). How easy is it to get these fitted and up un running? not to bad with the old spanner. could i do it myself or does it need professional assistance?

 

its fairly straight forward depending on what gauges you want,all involve connectiong a 12 volt feed and an earth to allow the gauges to work,and then the sender connection depending on what gauge you want...boost is just a pipe plumbed into one of the vacumn pipes on the inlet manifold,oil pressure and temp gauges require sender units fitting to the engine block,and a air fuel gauge needs a connection to the lambda wire on the ecu.... those are the main ones fitted but there are a big choice of units out there..... if you can use a multi meter or test light,and a soldering iron then your away....

 

Thanks for the help mate. i'll give it a go.