Hello all,

As you may know Scoob had a problem the other day with his check engine light - I've followed advice and connected the 2 black connectors and now have error code 12 and 32.

32 would make sense as the Oxygen Sensor - occasionally Scoob has been hesitating which in my mind makes sense as this sensor failing and then working again.

12 as the Starter Switch - well, I don't know where to begin with that one!

Any ideas where I can find more info about these and how to replace them? The tenants in my house aren't paying rent at the moment, so cash is - well, more than a little short! Would like to aviod taking him somewhere if I can fix it myself.

Thanks,

Jen

 

Reset the ECU and see if they reoccur.

 

Thanks ST,

Did some playing last night - reset the ECU (and I thought that was a myth!) Error 12 disappeared, so that must have been an old one but the Lambda sensor remained... tested the voltage and it held steady at between 0.32 and 0.34 even when blipping the throttle - so yup - it's buggered! :roll:

Will get a new one today

Jen