Okay...sould taking out a rear light be as simple as it looks??

You undo all the 8mm bolts from within the boot that hold on the light, and pop it out?

When looking at the rear of the light from outside the car, there is a little trim that goes just under the light...does this also need to come off for the light come out?

I have undone the bolts, however the light is not budging... seems there is black silicone holding this in..could this be the case...

--Sam

 

the sealer's a nightmare with these lights, you could 'try' warming it with a hair dryer, that might soften it a bit, but they're normally very wel stuck, the small bit of painted trim comes off with the light!!

 

This sealer was put on by Subaru to try and stop the wave of poeple fitting 'chav' lights to the car.... don't fight it. Leave the lights as they are and bin the cheap **** ****e you've just bought

Tony.

 

Just curious in how they would look that all....

 

Only pulling your leg

Tony.

 

rofpmfsl

piccy time tone ? ;-)

 

Tony, if i remember right...aint you got the Lexus lights on you car... ;-)


you think the hair dryer will do the job....??

 

LOL, Don't you even dare... i'll hunt you down like a dog .

Tony.

 

Might be a silly question, but you have undone all 5 bolts?