advice on heater control
#1
advice on heater control
hi on my heater control the circuit board has gone on the one that controls which direction the air comes out. Is there a quick way to get to the back of the control or is it a dash out job? The car is a 95 wrx .......thanks for your help Darren
Last edited by DAZZER; 22 October 2004 at 11:11 AM. Reason: spelling
#2
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
assuming it is the same or similar to the 96 UK.
You undo two screws above the dials in the surround and the vent / heater surround pulls off with vents attached etc..
The header is then held in with a couple of screws and it easy to see where to go from there I believe..
thinking I might have a picture [runs off to check]
found something
http://www.jollygreenmonster.fotopic.net/p836334.html
You undo two screws above the dials in the surround and the vent / heater surround pulls off with vents attached etc..
The header is then held in with a couple of screws and it easy to see where to go from there I believe..
thinking I might have a picture [runs off to check]
found something
http://www.jollygreenmonster.fotopic.net/p836334.html
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM