Tapping a WRX IC for pressure switch mounting?
20 October 2004, 12:48 AM
Scooby Regular
Thread Starter
Join Date: Sep 2003
Location: Sheffield
Posts: 3,577
Received 0 Likes
on
0 Posts
Tapping a WRX IC for pressure switch mounting?
I was thinking about tapping the rear of the IC on the N/S to mount my pressure switch for the water spray. Is the wall thick enough to allow this?
Its an MY98 WRX saloon. The switch is 1/4 bsp.
20 October 2004, 10:29 AM
Scooby Regular
Join Date: Sep 2002
Location: Cumbrian Scoobs
Posts: 2,616
Likes: 0
Received 0 Likes
on
0 Posts
When we had GEMS fitted to my mates rally car the i/c was drilled for a temperature sensor so it should be thick enough.
20 October 2004, 12:02 PM
Scooby Regular
Join Date: Jul 2000
Location: Lancashire
Posts: 2,209
Likes: 0
Received 0 Likes
on
0 Posts
The TMIC endtanks are cast, they are plenty thick enough to drill and tap.
Andrew...
21 October 2004, 01:16 AM
Scooby Regular
Thread Starter
Join Date: Sep 2003
Location: Sheffield
Posts: 3,577
Received 0 Likes
on
0 Posts
Cheers gents, much appreciated!!
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Manford
General Technical
6
16 September 2015 04:51 PM