anyone used a dastek piggy back ecu
#1
Scooby Regular
Thread Starter
Join Date: Aug 2001
Location: herts
Posts: 1,109
Likes: 0
Received 0 Likes
on
0 Posts
anyone used a dastek piggy back ecu
hi i have just bought a dastek piggy back ecu from a forum member,it has a boost clamp aswell...are these any good and where is the best place to have it fitted and mapped as i would like to fit this to my 93 ra...many thanks nigel
#3
Scooby Regular
Join Date: Aug 2003
Location: Not sure!!
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
Unichip
Hi There
Im writing from South Africa where they make the unichip.
I have one and am fairly satisfied. Im not sure where u can tune
it but i have my98 with a 56 mm exhaust and k&N filter.
Once tuned it made 184 bhp at the wheels running on 93 ron fuel !!!!!
and only 0.85 bar of boost around 11.5 psi .....Im also at an altitiude of 1600 metres above sea level and the temperature was 32 degrees celcius .... I think its not bad ....
leeps
Im writing from South Africa where they make the unichip.
I have one and am fairly satisfied. Im not sure where u can tune
it but i have my98 with a 56 mm exhaust and k&N filter.
Once tuned it made 184 bhp at the wheels running on 93 ron fuel !!!!!
and only 0.85 bar of boost around 11.5 psi .....Im also at an altitiude of 1600 metres above sea level and the temperature was 32 degrees celcius .... I think its not bad ....
leeps
#5
Scooby Regular
Join Date: Aug 2003
Location: Not sure!!
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
Another point to make you feel better is that quite a few scoobies here run the unichip ... no complaints that I have heard of ...
Those scoobies range from gts to wrx to sti ..... some even have been put on cars straight out of the shop ....
stis get about 226bhp at the wheels with a decat and unichip
Those scoobies range from gts to wrx to sti ..... some even have been put on cars straight out of the shop ....
stis get about 226bhp at the wheels with a decat and unichip
Thread
Thread Starter
Forum
Replies
Last Post
DogsofWar
Engine Management and ECU Remapping
16
23 September 2015 07:41 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM