Engine wants to stall after hard acceleration....
#1
Engine wants to stall after hard acceleration....
Hi
I've just imported a my99 wrx ra v limited. It starts, drives and stops fine.
However, if I accelerate briskly, and then come to a stop where the engine is idling, it will stall!
On other words, gentle driving is no problem ie no stalling problems, but after 'booting' it, it wont idle and i have to blipping the throttle to keep it running.
Any ideas much appreciated.
I've just imported a my99 wrx ra v limited. It starts, drives and stops fine.
However, if I accelerate briskly, and then come to a stop where the engine is idling, it will stall!
On other words, gentle driving is no problem ie no stalling problems, but after 'booting' it, it wont idle and i have to blipping the throttle to keep it running.
Any ideas much appreciated.
#4
Dyney, no dump valve. Dont think there are any air leaks, cannot hear anything hissing under the bonnet, surely it would try to stall all of the time not just after being driven fairly hard?
my94, i might try raising the timing a bit. I am using optimax but not octane booster, i will get some asap, and new plugs.
thanks guys.
any more advice appreciated.
my94, i might try raising the timing a bit. I am using optimax but not octane booster, i will get some asap, and new plugs.
thanks guys.
any more advice appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM