can i screw my MAF by just.....
#1
.....remove it from the housing for a few seconds?
My MAF housing is broken (2 of the "ears" where the MAF housing holds the induction kit are broken) and I want to replace the MAF housing. This is a no brain job, but since the MAf is held by 2 Torx screws, I was wondering if I can damage it by just unscrewing those screws and removing it and immediately bolt it back into the new housing?
Tks
My MAF housing is broken (2 of the "ears" where the MAF housing holds the induction kit are broken) and I want to replace the MAF housing. This is a no brain job, but since the MAf is held by 2 Torx screws, I was wondering if I can damage it by just unscrewing those screws and removing it and immediately bolt it back into the new housing?
Tks
#2
Scooby Regular
Join Date: Jul 2003
Location: Out of darkness cometh light
Posts: 1,457
Likes: 0
Received 0 Likes
on
0 Posts
Wouldn't have thought so, unless when you've removed it you suddenly have the urge to see the effect of microwaving it...!
Seriously though, they are fragile, but not that fragile. Just don't drop it or bash the sensor!
Seriously though, they are fragile, but not that fragile. Just don't drop it or bash the sensor!
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM