AFR meter readings (DAWES)
#1
PLEASE help i have just took my MY93 out to drive (Around 20 mins)and all i get is the red light flashing then other lights (Amber/Green) come on while accel. pedal half way ONLY) WOT then its pure RED light so no more WOT.......yet the DAWES device is opened as much as possible and i cant see any kinks in the hoses
I have connected the AFR wires to the following:
White to the WHITE wire on the Lambda (3 wire) sensor right? Black is connected straight to battery NEGATIVE
Red to the ignition input on the stereo (only available switched power if u know what i mean)
PLEASE help i am at a loss of what else i can do any and all help is very much appreciated
Thanks
[Edited by iffy - 11/2/2003 8:02:30 PM]
I have connected the AFR wires to the following:
White to the WHITE wire on the Lambda (3 wire) sensor right? Black is connected straight to battery NEGATIVE
Red to the ignition input on the stereo (only available switched power if u know what i mean)
PLEASE help i am at a loss of what else i can do any and all help is very much appreciated
Thanks
[Edited by iffy - 11/2/2003 8:02:30 PM]
#4
yes i did read the replies to my other post. But that one was wrote before i took the car out. Since then i have had the car under WOT in which the red light comes on, as i take my foot off the orange light comes on then the green briefly then red again. I understand then that the car is running to lean, what i want to know is what i can do to get it set correctly? how do i prevent it from running to lean?
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM