my00 ECutek 3
#1
Thinking about it
Is it worth it ?
what can I expect pwr and tourqe wise ??
current spec
MY00
Full scooby sport de-cat
kn57i induction
Dawes Device
What other mods would complement
Dont fancy big laggy turbo/FMIC ect
going to spend about £600 + the re-map
Anyone had it done at TSL ??
Tal
Is it worth it ?
what can I expect pwr and tourqe wise ??
current spec
MY00
Full scooby sport de-cat
kn57i induction
Dawes Device
What other mods would complement
Dont fancy big laggy turbo/FMIC ect
going to spend about £600 + the re-map
Anyone had it done at TSL ??
Tal
#2
Had this done on my MY00 by BRD, i would recommend removing the dawes and having a 3 port valve fitted though for the remap, much safer to have the ECU controlling boost than this IMO.
Gary
Gary
#4
Scooby Regular
iTrader: (1)
Join Date: Oct 2003
Location: Northamptonshire
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
Had my MY00 remapped at TSL a couple of weeks ago.
full decat,ITG panel,uprated fuel pump
So far no problems and i'm actualy getting more mpg.
Feels like a totaly different car,couldn't give you a figure of bhp but then again i'm not bothered all i wanted was usuable power that wasn't going to blow up the motor.Money well spent.
full decat,ITG panel,uprated fuel pump
So far no problems and i'm actualy getting more mpg.
Feels like a totaly different car,couldn't give you a figure of bhp but then again i'm not bothered all i wanted was usuable power that wasn't going to blow up the motor.Money well spent.
#5
Former Sponsor
iTrader: (234)
Gives you good results. I've had mine on for about 8 months now running 17.4psi boost and my turbo went earlier this week. Turbo only has 35,000mls on it. Me suspects it was the tek3 pushing it hard.
Not too bothered though as I will keep the tek3 and get a bigger turbo
Not too bothered though as I will keep the tek3 and get a bigger turbo
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM