HKS SSQV question.. urgent response needed..
#1
Scooby Regular
Thread Starter
Join Date: Jun 2002
Location: Nottingham
Posts: 5,285
Likes: 0
Received 0 Likes
on
0 Posts
I have MY00, just want to double check before I commit my cash..
That it will fit directly onto my HKS FMIC?
Am I going to need any brackets?
Any thing I missed is welcome..
Bit of a mechanical muppet so help is greatfully received
That it will fit directly onto my HKS FMIC?
Am I going to need any brackets?
Any thing I missed is welcome..
Bit of a mechanical muppet so help is greatfully received
#2
Ecu Specialist
You will/should get an adaptor to connect to the HKS FMIC, if its not being supplied then that will cost you extra, if you are considering fitting to a car running std ecu then my advice would be "don't", they can screw around with the maf, as a VTA item they can cause back pulses of pressure that can send the car lean causing severe jolting on gear shift.
#5
Scooby Regular
Thread Starter
Join Date: Jun 2002
Location: Nottingham
Posts: 5,285
Likes: 0
Received 0 Likes
on
0 Posts
nice one james..
would the recirc adapter affect the performance of th eunit in any way?
Also- I may be in touch about the 52mm piece if that is needed
Are the adapters MRT? where is the bestr place to source these?
would the recirc adapter affect the performance of th eunit in any way?
Also- I may be in touch about the 52mm piece if that is needed
Are the adapters MRT? where is the bestr place to source these?
#6
Ecu Specialist
It could especially be a problem if running extra boost, I really wouldn't go for it, they are expensive items to not work. You can't map around it using the factory ecu.
Thread
Thread Starter
Forum
Replies
Last Post
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM
jobegold@hotmail.co.uk
ScoobyNet General
2
27 September 2015 09:44 PM