PERRIN-08-14-SUBARU SILICONE-TURBO INLET HOSE
#1
Scooby Regular
Thread Starter
Join Date: Sep 2014
Location: doncaster
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
PERRIN-08-14-SUBARU SILICONE-TURBO INLET HOSE
Iv been looking to buy one of these.
Are these worth getting if im on the stock turbo.
They are quite expensive for what it is. On the perrin website it says it increases power and throttle response.
Any body actually noticed a difference with one of theses?
Are these worth getting if im on the stock turbo.
They are quite expensive for what it is. On the perrin website it says it increases power and throttle response.
Any body actually noticed a difference with one of theses?
#2
Scooby Regular
iTrader: (1)
Join Date: Aug 2006
Location: Newcastle
Posts: 621
Likes: 0
Received 0 Likes
on
0 Posts
It will look a lot better but I wouldn't bother as a stand alone upgrade it won't make any noticeable difference , apart from the cost its not a 5 min job to fit either.
The flow, composition and strength of a decent silicone turbo hose may be better than OE and Perrin gear is nice but I would spend my money elsewhere tbh
That said I got mine fitted (Samco)when the engine was out getting forged , made sense to fit it when getting it rebuilt combined with other upgrades.
cheers
Matt
The flow, composition and strength of a decent silicone turbo hose may be better than OE and Perrin gear is nice but I would spend my money elsewhere tbh
That said I got mine fitted (Samco)when the engine was out getting forged , made sense to fit it when getting it rebuilt combined with other upgrades.
cheers
Matt
Last edited by mattpat; 27 September 2015 at 09:10 PM.
#3
There are ebay jobbies of the same quality for £40. People use the ebay ones on other platforms without headache.
I was going to buy one for my stock turbo blob , but then i saw the ballache to fit. I wasnt prepared to cut up the stock inlet. So i am just making a custom SRI instead.
I was going to buy one for my stock turbo blob , but then i saw the ballache to fit. I wasnt prepared to cut up the stock inlet. So i am just making a custom SRI instead.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM