Pipe bending/FMIC pipes
29 May 2003, 08:30 PM
#1
Scooby Regular
Thread Starter
Join Date: Jun 2001
Posts: 10,211
Likes: 0
Received 0 Likes
on
0 Posts
I am trying to create a front mount for a non-scoob, I have sourced a core etc, but need some pipes made up/bent. Anyone know any companies in Essex area or suggest the type of company I should be looking for to do this.
If the first one works well then there may be demand for others, so I'd need someone who could replicate it again at a later date.
If the first one works well then there may be demand for others, so I'd need someone who could replicate it again at a later date.
29 May 2003, 10:45 PM
#7
Pace do a range of cast or fabricated alloy bends for use in alloy pipes, but that would mean welding in the bends.
Thin wall (1mm) stainless would probably work well, 1.5mm might be a touch heavy to use for the whole system. Ideally see if H&S can roll a bead on the end of the pipe for the hose to get a good mechanical grip on. MRT FMIC pipes are as I have described and seem to work well, they usually have it on display at PE for RR days.
Paul
Thin wall (1mm) stainless would probably work well, 1.5mm might be a touch heavy to use for the whole system. Ideally see if H&S can roll a bead on the end of the pipe for the hose to get a good mechanical grip on. MRT FMIC pipes are as I have described and seem to work well, they usually have it on display at PE for RR days.
Paul
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM