Help Fitting my Bosch coil packs!!!
03 May 2003, 01:55 PM
#4
Scooby Regular
Join Date: Jan 2001
Location: Down South to Ooop North to Back Down South again!!
Posts: 6,633
Likes: 0
Received 0 Likes
on
0 Posts
Here you go fella 
http://www.scoobynet.co.uk/bbs/threa...hreadID=188410
Good luck with it mate
MAFFA
http://www.scoobynet.co.uk/bbs/threa...hreadID=188410
Good luck with it mate
MAFFA
03 May 2003, 02:06 PM
#5
Scooby Regular
Thread Starter
Join Date: Dec 2002
Posts: 566
Likes: 0
Received 0 Likes
on
0 Posts
Maffa,
Your a gentleman thank you! I'm going to fit them next week, I'll post the results!
Did you just use standard leads from Halfords or did you get some uprated leads???
Cheers
Dom.
Your a gentleman thank you! I'm going to fit them next week, I'll post the results!
Did you just use standard leads from Halfords or did you get some uprated leads???
Cheers
Dom.
03 May 2003, 02:12 PM
#6
Scooby Regular
Join Date: Jan 2001
Location: Down South to Ooop North to Back Down South again!!
Posts: 6,633
Likes: 0
Received 0 Likes
on
0 Posts
I managed to source some standard red MY99 leads from a scooby & they were spot on. Put a post in wanted as you may get lucky but i've heard the standard MY99 ones from Halfords will do the same job I'm just a tart & wanted it all to match my red Samco's 
MAFFA
I'm just a tart & wanted it all to match my red Samco's MAFFA
03 May 2003, 06:02 PM
#7
Scooby Regular
Join Date: Mar 2002
Location: Fcon Power Writer
Posts: 4,338
Likes: 0
Received 0 Likes
on
0 Posts
HT leads are a bit of a muchness IMO, all of the tests that i have read/seen have given the same results no matter what leads.
Had to put Black ones on with my Coils, sold my fancy red ones
Rob
Had to put Black ones on with my Coils, sold my fancy red ones
Rob
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM