ive just got my new autometer ultralite AFR, anyone have the same AFR and how did you wire it up?

are there any instructions, Im fitting this to a UK MY98.

i know i have to solder one of the wires to a wire on the bottom block of the ecu, but which one?

cheers
chris

edited to add, the afr has 3 wires, Black, Red and Purple.

[Edited by CHRIS_D - 9/2/2002 9:54:47 AM]

 

Andy

i think john wants to see a pic of the AFR installed in the pod and how it looks rather than how its installed electrically (am i right john? ). cos i still aint got a clue which wire i need to put in on yet.

however i found this quite helpful:
here

just click on wiring (you'll need to download adobe acrobat if you havnt got it), and look for you're MY ECU. its for an apexi turbo timer but it tells you where the O2 sensor and a ground is.

just need to check it with regards to my ECU wires.......................again!

andy, i dont suppose you still have those instructions do you, i lost the last set you sent me.


Oh, BTW John YHM

chris

edited to say " wahey!!!!!......i got the link right first time"

[Edited by CHRIS_D - 9/3/2002 9:38:21 PM]

 

Have a look here http://www.scoobynet.co.uk/bbs/threa...hreadid=121306

The red is switched positive power, black is neg, purple signal.

 

Oops ignore that...it's for a 94

There was a thread that told you, but I can't remember where it is and search seems to have gone belly up....

I'll have a look and see if I can find it

 

Right, try this one

http://www.scoobynet.co.uk/bbs/threa...threadid=73947

 

Just a quick hijack....

Is the Autometer AFR gauge a standard 52mm thing, or is it smaller? All the pics I've seen are unclear on this.

Hope you can help. Thanks.

 

52mm. I wired mine to a T'd wire since I was replacing the o2 sensor as well.

 

BTT

ive had a look on ravensblades site, and although he says which wire it is (inc a MY98) its not the same as on my ecu.

imn ok woth a ll the wire bar the purple one, i know it goes t othe lamda sensor, but which wire is this on the ecu?

 

Chris

Hope you got this sorted, can you post a picture of it when it's fitted

Or email me one if its easier

Cheers m8

 

mega, dont forget your ecu is different wiring!!!

Not trying to teach you to suck eggs bud

 

Also

Are you two going to TRAX?

 

MD its the pod and gauge I wanted a picture off

Sorry I can't make Trax, got loads of doors I'm trying to hang this weekend should be fun

Cheers

J