1998 JDM STI compatible clutch master cylinder
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Aug 2009
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
1998 JDM STI compatible clutch master cylinder
Hello, I have a 1998 V4 STI import. I changed the slave cylinder, and tried to bleed the system, but failed (pedal stuck to the floor after depressing it). I wondered if the pedal position might need adjusting. Looking at the pedal the rod from the master cylinder that connects to it was messed up. The brass bit was badly bent, and was sliding up and down the rod as the centre threaded part of it had sheared off. [Sorry not very clear but hard to explain.]
I took the master out but can't salvage it without replacing the rod piece and the brass bit at the end. [Happy to buy them!]
Can anyone tell me which later master cylinders, if any, are fully compatible and the hard line will bolt right up? I don't want to buy a secondhand part from 1998ish if a nice newish part from a late model car will work well.
Also Import car parts website (where I got the slave part) is not working well today. If I remember their master was a lot more money than the slave.
Thanks for any advice. Tom
I took the master out but can't salvage it without replacing the rod piece and the brass bit at the end. [Happy to buy them!]
Can anyone tell me which later master cylinders, if any, are fully compatible and the hard line will bolt right up? I don't want to buy a secondhand part from 1998ish if a nice newish part from a late model car will work well.
Also Import car parts website (where I got the slave part) is not working well today. If I remember their master was a lot more money than the slave.
Thanks for any advice. Tom
Thread
Thread Starter
Forum
Replies
Last Post