stalling and idle control valve
#1
Scooby Regular
Thread Starter
iTrader: (24)
Join Date: Dec 2006
Location: oldham
Posts: 907
Likes: 0
Received 0 Likes
on
0 Posts
stalling and idle control valve
on my wr1 had issue with stalling, update today the car had attempted to stall few times so when the car arrived home from my wife working attemted to get the control valve off and replace with a fresh one from a runner with a new gasket once all tightened down and started car noticed a hissing noise and found that the t piece for the dumpvalve was broken and sucking in air now i wont know if this was the problem to start with and dont want to take off again as new gasket replaced , the issue i have now is the management light is on so does it need re setting or not as car will not be run until tomorrow
also the part i have replaced with was from a jap import not sure if same as uk spec
also the part i have replaced with was from a jap import not sure if same as uk spec
Thread
Thread Starter
Forum
Replies
Last Post
imprezachris88
General Technical
6
01 April 2016 07:18 PM
crazyspeedfreakz
ScoobyNet General
5
29 March 2016 07:38 PM
B8MEE
Subaru Parts
0
23 March 2016 06:48 PM