Hybrid TD04 and catless up pipe questions
#1
Hybrid TD04 and catless up pipe questions
Hi, I`m about to get back a td04 from C and R turbos with a drop in billet and 360 thrust bearings, and then it`s going on my SL 05 wagon; whilst I`m at it, the up pipe will be swapped for an sti one.
Firstly,can anything else be done to improve the turbo ? I`ll be adding supporting mods one by one, injectors, tmic etc. Is it worth porting anything ?
Secondly, in changing the up pipe, what needs to be done to stop the cel coming on ? If I buy a custom trick up pipe instead of an sti one, can this be avoided?
Any other jobs worth doing whilst it is all off?
Many thanks
Firstly,can anything else be done to improve the turbo ? I`ll be adding supporting mods one by one, injectors, tmic etc. Is it worth porting anything ?
Secondly, in changing the up pipe, what needs to be done to stop the cel coming on ? If I buy a custom trick up pipe instead of an sti one, can this be avoided?
Any other jobs worth doing whilst it is all off?
Many thanks
#4
Thanks. Realistically, 300 would be good; I`m at 279 at the moment with sports cat, panel and remap. I would hope for a little more with a sti tmic, maybe, but am going to take it a step at a time. How did you find the change with the sti up pipe ? I`m just after back road daily drivability, really. I was going to get the existing injectors cleaned as well.
#5
Scooby Regular
iTrader: (3)
if you can get the headers ported you'll see a little gain as well - standard headers take the treatment very well from what i've read.
You can also knock out the EGT cel with a resistor if you need a temporary fix to drive on:
http://www.clubwrx.net/forums/engine...istor-mod.html
But if your getting it mapped then never worry about it and as said the mapper will wipe out all the codes anyway.
You can also knock out the EGT cel with a resistor if you need a temporary fix to drive on:
http://www.clubwrx.net/forums/engine...istor-mod.html
But if your getting it mapped then never worry about it and as said the mapper will wipe out all the codes anyway.
#6
Scooby Regular
iTrader: (2)
Join Date: Dec 2007
Location: Horsham, Sussex
Posts: 784
Likes: 0
Received 0 Likes
on
0 Posts
I'm on 279BHP 301lb-ft with fuel pump, full decat, plugs, panel filter, remap. This is on my 05 WRX SL PPP Wagon.
I did all this in one go so its hard to tell what the up pipe did. All I know is that the above transformed the car the pull from low rpm is awesome. It's on a par with my classic STI I had. I just wish it had more top end......
I'd be interested to know what your turbo cost as I think that's the next step for me with 550 injectors.
I did all this in one go so its hard to tell what the up pipe did. All I know is that the above transformed the car the pull from low rpm is awesome. It's on a par with my classic STI I had. I just wish it had more top end......
I'd be interested to know what your turbo cost as I think that's the next step for me with 550 injectors.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
hedgecutter
General Technical
3
25 September 2015 02:35 PM