Failure on route to work this morning :-(
#1
Scooby Newbie
Thread Starter
Failure on route to work this morning :-(
Hi folks
First off, I've be on here since November when I got my first Scoob and been kinda lurking in the background, listening and learning since. Apart from the odd crazy I've noticed, I'm loving Scooby net so thanks!
This morning I've had some kind of drive train failure on route to work. I have an 06 Hawk WRX Wagon. I was driving normally just under £40 on country roads not pressing on at all when revs picked up and at the same time got a grindy noise from front end more right that left I think.
The engine still rev'd as normal and went in to ever gear as normal but had barley any drive and clutch burn when trying to move the car further.
It's with my mechanic now (Alan car man) an he is going to try to have a look at it this afternoon if he can.
Place you bets! I will post the failure as soon as I know...
Tom
First off, I've be on here since November when I got my first Scoob and been kinda lurking in the background, listening and learning since. Apart from the odd crazy I've noticed, I'm loving Scooby net so thanks!
This morning I've had some kind of drive train failure on route to work. I have an 06 Hawk WRX Wagon. I was driving normally just under £40 on country roads not pressing on at all when revs picked up and at the same time got a grindy noise from front end more right that left I think.
The engine still rev'd as normal and went in to ever gear as normal but had barley any drive and clutch burn when trying to move the car further.
It's with my mechanic now (Alan car man) an he is going to try to have a look at it this afternoon if he can.
Place you bets! I will post the failure as soon as I know...
Tom
#5
Scooby Newbie
Thread Starter
Hi
Jura11 and scottyPPP You are bang on it was the shaft and could have been the pin to, it let go on the outer wheel end. I am now on the hunt for a good outer shaft!
Thanks Tom
Jura11 and scottyPPP You are bang on it was the shaft and could have been the pin to, it let go on the outer wheel end. I am now on the hunt for a good outer shaft!
Thanks Tom
#7
Scooby Regular
iTrader: (7)
Hi Tom
Driveshaft failures are,but on our wagon which run WRX driveshafts at various bhp levels from 250bhp to 555.5bhp without the issue,only once failed front driveshaft,when alignment company forgot to align correctly driveshaft pin
But still driveshaft failures are pretty rare,but yes they happen and as above please speak with Matty@MB Developments,he is great guy and he will source you good driveshafts
Thanks,Jura
Driveshaft failures are,but on our wagon which run WRX driveshafts at various bhp levels from 250bhp to 555.5bhp without the issue,only once failed front driveshaft,when alignment company forgot to align correctly driveshaft pin
But still driveshaft failures are pretty rare,but yes they happen and as above please speak with Matty@MB Developments,he is great guy and he will source you good driveshafts
Thanks,Jura
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM