As titled. I have no brakes. I've bled the whole system. New fluid topped up. No leakeage. The pedal when pressed is as it should be when the car is off but when the car is on there's nothing there and the pedal goes down to the floor. Banny said it could be that i haven't connected the servo line to the inlet manifold or the one way valve? Now i need a pictures or diagrams to show me where these are located as i have no idea where to look. Thanks

 

have you carried out any work on the car prior to brake failure?

 

The car has been built from shell

 

ok so a simple one to start are the calipers on the right sides. bleed nipple at the top. its possible to fit them to the wrong side

 

Ok just had a look my front one's are on the top. But my back one's look like the nipples are on the bottom

 

Get pics of the engine and brakes up, make things easier for everyone to locate the issues. As most likely you will have more than one by the sounds of it

 

if nipples are at bottom they wont bleed properly. swap the rear calipers over

 

Ok can i send them to you and u upload bro? My photoucket is being a b**tch and won't let me upload

 

sure no probs

 

Pics

 

Cheers banny. The pipes seem to be connected. I think it could be that one way valve thats supposed to be in the pipe, been told to feel a bulge in the pipe bt i cant feel it so that may be the issue?

 

Yes the rear calipers are on upside down so swap them side to side , the AP calipers have bleed nipples on the inside and outside , you need to bleed them both
Cheers Ian

 

Woah didn't knw that lol