v1-v2 ra will idle but wont rev up
#1
Scooby Regular
Thread Starter
v1-v2 ra will idle but wont rev up
hi all ive just finished off putting the engine in my track car it will idle but wont rev up also sounds like its blowing air back thru the air filter ive plumbed up the vac pipes correctly and its made it better but still wont rev no fault codes on the car could this be to do with the throttle position sensor as I removed it to powder coat the manifold or does anyone have any ideas what could be causing this
#2
Scooby Regular
When putting the sensor back in did you make sure that its spring loaded ,, ie you have to put it in on a angle then spin it till its lined up which puts load on the spring
This is what I had to do with my newage anyway so might be worth a try
This is what I had to do with my newage anyway so might be worth a try
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
supshon
General Technical
2
03 October 2015 08:06 PM