hey good people installing my electric boost gauge tomz from pro sport scoobworld told me to use the pipe on the inlet manifold but was wanting to no if anyone had photos of a 1998 engine bay with this pipe pointed out and wiring advice would be a great help to thanks

 

Use the pipe on the dump valve matey......

 

was going to do that but advised other pipe for better read out

 

You will be fine there mate...

 

I tee'd off the fuel pressure regulator to inlet manifold tube,had no issues at all with it....

 

any photos

 

The manifold is the most accurate. My 99 had a nipple on the manifold that wasnt used and had a rubber cover on it.

 

mine should have that to then ? you got a photo im quite basic with stuff like that

 

here you go.........



you can see the tee piece(it is the white bit by the cable tie)
the second photo is where i've tee'd into.....to the right of the circle with the cross in it.....follow that tube it'll go to the fuel pressure regulator,cut that and insert your t piece

hope this helps

 

wow your a hero but what about the spare nipple you sed you just put it into

 

my bad that was someone else lol

 

The tube that is to the right of the circle with a cross in it runs to the fuel pressure regulator,if you follow it down you'll see what I mean.....
Then cut it,insert your tee piece,then the spare end on your tee piece goes to your boost sensor/gauge....