uprated fuel pump wiring?
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jan 2004
Location: Hertfordshire
Posts: 4,312
Likes: 0
Received 0 Likes
on
0 Posts
uprated fuel pump wiring?
I'm wanting to uprate the pump wiring on my newage car. I dont have a problem with doing the wiring. I will use the o/e wiring to excite a relay.
The issue im stuck with is how do i pass the new wiring through the top of the sender unit and keep it sealed.
I dont want to use the o/e plug for the pump as its already melted the two pump wires. But i will retain it for the fuel guage.
Any suggestions on how to keep it sealed and safe welcomed
Mel
The issue im stuck with is how do i pass the new wiring through the top of the sender unit and keep it sealed.
I dont want to use the o/e plug for the pump as its already melted the two pump wires. But i will retain it for the fuel guage.
Any suggestions on how to keep it sealed and safe welcomed
Mel
#2
Scooby Regular
iTrader: (2)
Remove that part from the car (well away) allow fuel vapor from it to dissipate (remove sock filter etc) potentially wrap all the lower section in a bag or similar and then drill a hole in the cover. Use a tight fitting grommet and then seal with a good sealant? Make sure no metal fragments get in the sender etc (hence wrapping).
Thread
Thread Starter
Forum
Replies
Last Post
hedgecutter
General Technical
3
25 September 2015 02:35 PM