SCOOBERATORS

I have just put my car back to standard .
link ecu
hks racing suction air filter.

since then i have had the engine light on.
but the car wont boost properly it holging back and the tick over is up and down.

A friend has just put is subaru lap top on it and its coming up as the air flow meter.

anyone else had this problem.

Thanks Richard.

ozzy

Does a Bear **** in the woods?

It's quite a regular thing, especially with aftermarket air filters or induction kits.

Some folk have swapped them and ran for years without ever having problems; others change it and within days, the MAF's buggered.

What "Suabru laptop" did your m8 use? Deltadash or a Select Monitor or something else?

I've seen the MAF cleaned and fixed (although apparently his car has developed the problem again a good few weeks down the line), but it usually needs replaced.

It was around £300 , but apparently you can get just the sensor in Greece and the US for around £50-£60. It's worth investigating if it's available over here for the same cost.

Stefan

AlanG

A thread going back years ago highlighted that unsupported replacement *induction kits* can cause failure of MAF sensors due to vibration.

Probably why K&N supply there kits with a support bracket.......

A

SCOOBERATORS

My air filter did have a support bracket

Cheers lads.

SoreHead

I was speaking to my dealer who said they would leave my warrantee with limited mods but warned that they had 2 failures of MAF after intake systems were fitted.
The techie in Performance Subaru was telling me it's the systems that are oil infused that cause it and the paper kind are ok (or what ever their made of). I think the HKS is teh oil infused foam type so that might explain that.

SCOOBERATORS

You was all correct and its all sorted now

cheers