Need some advice on this Blob eye !
#1
Need some advice on this Blob eye !
Hi everyone, I'm looking to purchase a Blob eye WRX, and I have seen quite a few. There is one that looks really clean, but there's just one problem. There is some duct tape on the connection just under the intercooler on the BOV (?) I'm not 100% clued up on these cars so I would be greatful if someone could tell me if this is something serious/ expensive to sort or quite easy.
#2
Scooby Regular
looks like they have had a leak on the vacuum hose for the dump valve and have taped it up. Very cheap and easy to replace just buy a length of vacuum hose long enough and replace it. Doubt it will cost you £5.
The only thing I would add is that I am pretty sure it isn't routed correctly but that could be addressed when it is replaced
The only thing I would add is that I am pretty sure it isn't routed correctly but that could be addressed when it is replaced
Last edited by robj2502; 16 May 2014 at 12:03 PM.
#4
Scooby Regular
iTrader: (12)
Join Date: Jun 2007
Location: Moved to the Darkside
Posts: 5,034
Likes: 0
Received 0 Likes
on
0 Posts
It looks to me like he's been changing hoses and has put bits of tape on to note which goes where. If you look closely you can see tape on a few other pipes as well, behind the top mount and over near the boost solenoid.
Last edited by Aaron1978; 17 May 2014 at 09:05 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM