idle control valve
#1
idle control valve
Hi,
This morning my throttle cable became stuck, I sprayed wd40 on it etc...But all day its been idling at 2000-3000rpm. Then it throws a engine light after stop start traffic, which turns out to be icv fault. Cleared the fault but it came back after 20mins.
Would the sticky cable throw up this error and more than likely go when fixed?. Or...Would it be a new icv needed?.
Its a 2003 bugeye.
Lee
This morning my throttle cable became stuck, I sprayed wd40 on it etc...But all day its been idling at 2000-3000rpm. Then it throws a engine light after stop start traffic, which turns out to be icv fault. Cleared the fault but it came back after 20mins.
Would the sticky cable throw up this error and more than likely go when fixed?. Or...Would it be a new icv needed?.
Its a 2003 bugeye.
Lee
#3
The engine light has gone out now...I'll get the cable sorted and clean the icv out tomorrow, hopefully it sorts it.
Im wondering if it is to do with the cable, as it wasn't sticking as bad as earlier then the light went out.
Im wondering if it is to do with the cable, as it wasn't sticking as bad as earlier then the light went out.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
supshon
General Technical
2
03 October 2015 08:06 PM