Some advice required
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Sep 2012
Location: Essex
Posts: 1,250
Likes: 0
Received 0 Likes
on
0 Posts
Some advice required
Been looking for a while for a OEM rear spoiler for my STI, ideally complete boot and spoiler, found one but no response from seller so would assume that's a none starter, found mint spoiler on its own and if I bought this I am looking for a good body shop that can seal and fit, any surgestions on if anyone has got what I am looking for or bodyshop?
Cheers.
Cheers.
#2
Scooby Regular
Haven't a clue dude. Wouldn't it be a direct fit? All holes where they should be? Might be worth doing yourself with some decent sealant around the edges and on bolt holes? Have you looked for a DIY guide or anything? I'm sure time and persistence will lead to a more satisfying job. Either that or hold out for a lid too.
#3
Not too hard really.
The holes in the boot will line up with some of the tabs. The. You'll have to drill two more if you wish.
If not its a case of a thin bead round the holes then use some thin double sided foam tape round the edges. That's it.
The holes in the boot will line up with some of the tabs. The. You'll have to drill two more if you wish.
If not its a case of a thin bead round the holes then use some thin double sided foam tape round the edges. That's it.
#4
Scooby Regular
Jamie at classic scooby bits, the regular answer tbh. Fitted a carbon fibre one to Alans WRX, Hawk STI to Rich's RB5 and a Championship Hawk spoiler to his Ver2 WRX.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
gazzawrx
Non Car Related Items For sale
13
17 October 2015 06:51 PM