Some advice required
 

Been looking for a while for a OEM rear spoiler for my STI, ideally complete boot and spoiler, found one but no response from seller so would assume that's a none starter, found mint spoiler on its own and if I bought this I am looking for a good body shop that can seal and fit, any surgestions on if anyone has got what I am looking for or bodyshop?
Cheers.

Haven't a clue dude. Wouldn't it be a direct fit? All holes where they should be? Might be worth doing yourself with some decent sealant around the edges and on bolt holes? Have you looked for a DIY guide or anything? I'm sure time and persistence will lead to a more satisfying job. Either that or hold out for a lid too.

Not too hard really.

The holes in the boot will line up with some of the tabs. The. You'll have to drill two more if you wish.

If not its a case of a thin bead round the holes then use some thin double sided foam tape round the edges. That's it.

Jamie at classic scooby bits, the regular answer tbh. Fitted a carbon fibre one to Alans WRX, Hawk STI to Rich's RB5 and a Championship Hawk spoiler to his Ver2 WRX.

Jamie is the only person you need to go and see mate. We fitted my spoiler to mine with no holes or guidance in the carbon fibre boot lid. Took us 4 hours from start to finish. Im over the moon with the product!!!!

he (Jamie) currently has a few spoilers available and one is in fact Blue and for your model.... i think?! give him a call.

defo give jamie a shout , he is in the process of painting mine and will be fitting it for me too

Anyone got his number?
Cheers

07770 596 334

:thumb: