kevin wrx

iTrader: (1)

I have a problem of when car is on boost it holds back and jerks,the car my 95,i connected the wires up under the dash and the boost soloniod was clicking,so does that mean the boost soloniod is ok,and what can i clean soloniod out with,also speedo is not working and showing fault code 33 which is speed sensor,would that fault have anything to do with the boost problem.i am also after a set of clocks if anyone has any thanks.

Curtis450

Try the speed sensor on the gearbox. Carb cleaner is ok to clean it with but yes it is working if it clicks matey. Giving it a clean may help.

WRX_Dazza

speedo problems can cause the car to go into limp mode, but this wont cause jerkiness, prob you're coil packs fubar'd.

there might be a charitable person on here that could lend you a set to try (changing one is false economy by the way as they do seem to degrade at the same time - been there done it)

TomR555

iTrader: (1)

had the same prob with mine,have a look around always stuff hanging around here

kevin wrx

iTrader: (1)

dont think its coils as do ecu reset and car is fine even on boost for a bit but then throws up speed sensor code and starts holding back on boost,so can guess it goes into limp mode,didnt think a cable would cause that problem.

kevin wrx

iTrader: (1)

is the speed sensor the cable its self or what the cable goes onto on the back of the clocks or were is it located on gearbox

Curtis450

On the top mate, can be seen from bay but is right under.

kevin wrx

iTrader: (1)

does the cable go into the sensor attached to the box end and any chance of any pics of one,