p1-uk2000 complete swap,ecu problem!
16 October 2013, 02:02 AM
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Nov 2010
Location: baraņain, basque country
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
p1-uk2000 complete swap,ecu problem!
hello from spain
i install on my impreza gt turbo my2000(ukturbo in spain) a complete engine from my p1,with the ecu from the p1,and when i turn the key,the gas pump doesnt make any noise. i read a lot of similar posts here and i think the problem are the ecu pins from p1 are diferent from p1 ecu and oem uk turbo. someone can say me wich pin its necessary change?time ago i instal apexi power fc ecu,and was necessary change the camshaft signal pin with other signal pin to start the engine.
thank you very much and please sorry for my bad englis
CAN BE DELETE! I FIND THE ANSWER IN THIS FORUM, THANKS!!!!
i install on my impreza gt turbo my2000(ukturbo in spain) a complete engine from my p1,with the ecu from the p1,and when i turn the key,the gas pump doesnt make any noise. i read a lot of similar posts here and i think the problem are the ecu pins from p1 are diferent from p1 ecu and oem uk turbo. someone can say me wich pin its necessary change?time ago i instal apexi power fc ecu,and was necessary change the camshaft signal pin with other signal pin to start the engine.
thank you very much and please sorry for my bad englis
CAN BE DELETE! I FIND THE ANSWER IN THIS FORUM, THANKS!!!!
Last edited by mikelatz; 16 October 2013 at 02:28 PM. Reason: delete
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
38
17 July 2016 10:43 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM