Fitting MY99 MAP to V1/2 wiring (URGENT!!)
#1
Fitting MY99 MAP to V1/2 wiring (URGENT!!)
Hi guys,
My car is off for mapping on Tuesday, just doing the last few bits to get it ready but realised i'd completely forgotten to fit the later model MAP sensor!
Now i have the new sensor, complete with a length of the loom & plug for it, but can't find anywhere a diagram for the wiring.
Both are 3 wire, the old sensor has pink, green & white wires. The new sensor has red, yellow & black.
Does anyone know which goes to which?
I did search but had no luck, hopefully someone is able to help out
Thanks a lot everyone,
James
My car is off for mapping on Tuesday, just doing the last few bits to get it ready but realised i'd completely forgotten to fit the later model MAP sensor!
Now i have the new sensor, complete with a length of the loom & plug for it, but can't find anywhere a diagram for the wiring.
Both are 3 wire, the old sensor has pink, green & white wires. The new sensor has red, yellow & black.
Does anyone know which goes to which?
I did search but had no luck, hopefully someone is able to help out
Thanks a lot everyone,
James
#2
Further searching has found the answer!
Just in case anyone else needs to know;
https://www.scoobynet.com/general-te...3-classic.html
Just in case anyone else needs to know;
https://www.scoobynet.com/general-te...3-classic.html
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM