safe bhp
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jan 2012
Location: south wales
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
safe bhp
iv got a 1998 uk turbo, will be having a esl daughterboard fitted soon with TD05 turbo,440 yellow injectors,
what will be the safest maximum amount of bhp to take my car to without putting to much strain on the engine and box.?
what will be the safest maximum amount of bhp to take my car to without putting to much strain on the engine and box.?
#3
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jan 2012
Location: south wales
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
milage not known as the clocks have been changed and only got last mot,only owned the car 3 months. it did have engine rebuild less than 2 years ago got reciepts to show that
#5
Scooby Regular
Join Date: May 2012
Location: Nottingham
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
I've been told a standard classic with a td05 can be mapped to 350ish but normally leave it at around 330 to be safe mate but I'm guessing with a forged re-build you can expect higher but a fmic will be needed,and plz don't forget your brakes,
Trending Topics
#9
Scooby Regular
Join Date: May 2012
Location: Northern Ireland, Co.Down
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
get aftermarket panel filter
decat
phase 1.5/2 sti tmic,no need for a fmic unless over 400, but everyones to their own. But you'll see bigger gains with tmic under 400bhp
and id say 310-330 max, the td05 could take about 350 as stated but to be safe id aim below
and then ofcourse a map on ur esl daughter board, brakes and if needed, a new clutch plate or all of it will be for nothing bud. hope thats a bit of help
decat
phase 1.5/2 sti tmic,no need for a fmic unless over 400, but everyones to their own. But you'll see bigger gains with tmic under 400bhp
and id say 310-330 max, the td05 could take about 350 as stated but to be safe id aim below
and then ofcourse a map on ur esl daughter board, brakes and if needed, a new clutch plate or all of it will be for nothing bud. hope thats a bit of help
#12
Ecu Specialist
With those mods you should see 320 to 330 bhp given the use of decent fuel and that should not cause you any problems. If the clutch is original/oem that might play up.
Mechanically the engine could take 380 to 400 bhp with the right supporting mods on the car, the box will run with that, its torque that hurts the box not power at the top end and so the torque delivery needs to be progressive not a big '******" iyswim.
But your mapper should be au fai with all of that in any case.
cheers
bob
Mechanically the engine could take 380 to 400 bhp with the right supporting mods on the car, the box will run with that, its torque that hurts the box not power at the top end and so the torque delivery needs to be progressive not a big '******" iyswim.
But your mapper should be au fai with all of that in any case.
cheers
bob
Thread
Thread Starter
Forum
Replies
Last Post