Not boosting past 0.7 bar
#1
Scooby Regular
Thread Starter
Not boosting past 0.7 bar
Hi,
I’ve been having problems with boosting past 0.7 bar. It reaches that perfectly fine but doesn’t seem to wanna go over that. Checked all the lines and hoses etc, but nothing seems out of place. Could it just be that my 3 port has given up ?. I have a 2008 wrx hatch
I’ve been having problems with boosting past 0.7 bar. It reaches that perfectly fine but doesn’t seem to wanna go over that. Checked all the lines and hoses etc, but nothing seems out of place. Could it just be that my 3 port has given up ?. I have a 2008 wrx hatch
#2
Scooby Regular
iTrader: (4)
I had a similar issue recently too and it turned out my boost solenoid had almost seized up.
Even though a bought a replacement, i managed to strip down my old one and service it to bring it back to life. Instantly fixed the issue and now boosting even better then it did before.
Even though a bought a replacement, i managed to strip down my old one and service it to bring it back to life. Instantly fixed the issue and now boosting even better then it did before.
#3
Scooby Regular
Thread Starter
I had a similar issue recently too and it turned out my boost solenoid had almost seized up.
Even though a bought a replacement, i managed to strip down my old one and service it to bring it back to life. Instantly fixed the issue and now boosting even better then it did before.
Even though a bought a replacement, i managed to strip down my old one and service it to bring it back to life. Instantly fixed the issue and now boosting even better then it did before.
#4
Scooby Regular
Thread Starter
I’ve just bought a new 3 port but I’m having the same problem. I’m assuming buying a new one, it needs to match the same serial number as my old one etc ?. My old solenoid came back to life and I was in full boost again, but now it’s gone back to not going past 0.6 bar. Might book myself in with my mapper
Thread
Thread Starter
Forum
Replies
Last Post