Mickmick1212

Hi, i bought a used 2004 sti US and have a psi3 version 10 in it. Its working and read data but when it open the serial number is : 00000000. Plus i got 2 alarm that flash every 30sec.
1-payment time expired
2-data configuration failed
I saw on some forum that a security code need to be entered but i dont have any serial number???
i need help

Mickmick1212

Gambit

iTrader: (6)

i had that payment time expired issue previously and it cannot be rectified without sending it back to be repaired (needs a new microprocessor) this is then where it becomes an issue as PSI3 no longer exist so you need to contact the fella who made them directly. SimonB@auwell.co.uk who obviously is based in UK

it cost me £75 to repair mine back in 2014 including carriage BUT it took me about 9mths to get it back from him - they arent worth it anymore especially with Torque App doing all the same stuff and more. onyl really useful if you have a classic subaru as they are not obd compliant

Mickmick1212

Well thanks for that fast reply. I think i will just give up psi3 monitor.

Hawkeye D

I can email you a PDF of the PSi3 instruction manual, but doubt that can really help reading other replies, but happy to email it to you all the same...

Mine is an original PSi3 and had it now must be 5 or 6 years (thanks again Tim!) and I've never had a message once. Maybe Ecutek changed them when they bought PSi3 out.
You can change alarm parameters on mine.

Mickmick1212

I can change alarm setting too but only for boost,oil pressure and thing like that. Yes send me the pdf please.
mick_hockey1@hotmail.com

Mickmick1212

yes please : mick_hockey1@hotmail.com