P0301 continuous led to piston melt after a rebuild :-(
#1
Scooby Regular
Thread Starter
Join Date: Dec 2010
Location: Llanelli South Wales
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
P0301 continuous led to piston melt after a rebuild :-(
Hi, hoping to get to the bottom of the problem.
Piston melted :-( 8000 miles after a rebuild?
I'm having it Rebuilt again but must stop the piston melting problem.
Misfire at boost 3500rpm.
P0301
Plugs new
Coils swopped around
Extra earth's to engine
Fuel filter
I had lean fault with tesco momentus
Then used V power until the present tank of fuel standard shell petrol which is still in the car.
New MAF sensor Pierburg manufacturer
Would a denso work better?
I thought it was when i bought it. The car did run more smoothly after fitting the new MAF Sensor.
Wits end can't have this rebuild melt on me as well
2001 bugeye wrx
Standard completely not even an exhaust.
Pleeeeeeeeeeeeease of you can help
👍👍👍👍👍👍🚗💨💨💨
Piston melted :-( 8000 miles after a rebuild?
I'm having it Rebuilt again but must stop the piston melting problem.
Misfire at boost 3500rpm.
P0301
Plugs new
Coils swopped around
Extra earth's to engine
Fuel filter
I had lean fault with tesco momentus
Then used V power until the present tank of fuel standard shell petrol which is still in the car.
New MAF sensor Pierburg manufacturer
Would a denso work better?
I thought it was when i bought it. The car did run more smoothly after fitting the new MAF Sensor.
Wits end can't have this rebuild melt on me as well
2001 bugeye wrx
Standard completely not even an exhaust.
Pleeeeeeeeeeeeease of you can help
👍👍👍👍👍👍🚗💨💨💨
Thread
Thread Starter
Forum
Replies
Last Post