Mark1983

iTrader: (2)

After a bit of advice...

I have a MY05 Impreza STI PPP. As of lunch time today the lever on the gearstick you pull up the engage reverse is stuck in the up position and it won't return it's original postion. Because of this I can't engage 5th or 6th gear.

Any advice other than taking it to the garage? Subaru dealers aren't too common round my way.

Thanks,

Mark

GlesgaKiss

Have you tried everything to get it back down i.e brute force? Then if you break it, take it to a dealers.

Mark1983

iTrader: (2)

I tried, I'll try a bigger hammer

Mark1983

iTrader: (2)

Ive removed the screws and taken the panel out. There's no tension on the cable that pulls the lever down...

merlin24

iTrader: (1)

Has the roll-pin broken (just below where the gear **** screws on) ??

maydew

iTrader: (9)

check the linkage from under the car not sure if its cable/spring loaded been a while since had the box out lol,its to the rear of the box

APIDavid

iTrader: (4)

Either the pin for the selector cable for reverse has broken/fallen off or the cable has broken.

I'd have said that the plunger was just stuck up inside the actual gear ****, but that is unlikely if the cable is slack.

David APi

Agents for:
Simtek, the most exciting new Ecu for years
Buddy Club exhausts
Scoobysportexhausts
Eibach suspension
Hybrid front mount intercooler kits
AP Racing brakes and clutches
And of course; the well known APi Performance Exedy organic clutch

www.apiengines.com

01926 614333

Mark1983

iTrader: (2)

Thanks for the input guys.

I think it's a Subaru job, it's still under manufacturers warranty. There's a couple of other warranty jobs need doing so I'll get them all done at once.