Downpipe Mounting Advice?
#1
Scooby Regular
Thread Starter
Join Date: Sep 2002
Location: Nottingham
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
Downpipe Mounting Advice?
A couple of question on downpipe fitting on a UK MY98.
1) Should this have two mounts? (front upper and lower back?)
2) Any advise on what to do if the rear conical-gasket thing seems too small or loose-fitting?
Cheers,
Andy
1) Should this have two mounts? (front upper and lower back?)
2) Any advise on what to do if the rear conical-gasket thing seems too small or loose-fitting?
Cheers,
Andy
#3
Scooby Regular
Thread Starter
Join Date: Sep 2002
Location: Nottingham
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by ReggieMY99
the downpipe hangs in the turbo mount going down its attached to the center section nothing else
you need to be able to get to the car from both above and beneath
you need to be able to get to the car from both above and beneath
Going to fit a Hayward & Scott downpipe
http://www.haywardandscott.com/Detai...48&category=13
...and noticed that it only has one bracket, whilst others like the Nija system has two:
http://www.scoobyworld.co.uk/catalog...s/ninja_dp.jpg
Cheers,
Andy
#5
Scooby Regular
Thread Starter
Join Date: Sep 2002
Location: Nottingham
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by tath
on mine it's bolted to the turbo and has a bracket just before the join to middle pipe? (95 STI)
Andy
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
supshon
General Technical
2
03 October 2015 08:06 PM