Det can location
#2
on the block, there should be somewhere convenient about 75mm above the factory knock sensor location where the engine meets the box.
Also you can slot the hole in the copper pipe to put under the factory sensor which can work quite well depending on your intercooler placement etc.
Paul
Also you can slot the hole in the copper pipe to put under the factory sensor which can work quite well depending on your intercooler placement etc.
Paul
#3
Thanks Paul. Its currently has two pipes, one at each end of the cylinder heads which I thiink gives too much drive train noise. I will relocated with 1 pipe into copper, at location you state. Cheers agzain.
#5
Former Sponsor
iTrader: (4)
Join Date: Jul 2003
Location: @Junc 12, M40 Warwicksh; 01926 614522 CV33 9PL -Use 9GX for Satnav. South Mids Alcatek ECu dealer
Posts: 6,377
Likes: 0
Received 3 Likes
on
3 Posts
Originally Posted by Andy.F
You can bolt it anywhere on the metal part of the engine and still hear the det clearly, it's just the volume that changes from location to location.
Andy
Andy
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM