How difficult is a rocker gasket to change
#2
I did mine the other week.
Its not hard but time consuming.
its basically taking off all the
air filter assembly
header tank
then once all thats out the way you can get to the cover.
6 bolts
remove old gasket - clean up as mine was a mess, in bits.
then put new one's on.
one main one around the edge
two around the spark plugs.
and 6 rubber washers for the bolts.
done!.;
hope this helps..
oh took me 4.5 hours! hehe
Its not hard but time consuming.
its basically taking off all the
air filter assembly
header tank
then once all thats out the way you can get to the cover.
6 bolts
remove old gasket - clean up as mine was a mess, in bits.
then put new one's on.
one main one around the edge
two around the spark plugs.
and 6 rubber washers for the bolts.
done!.;
hope this helps..
oh took me 4.5 hours! hehe
#3
Cheers Magnet,
Thanks for the quick reply, i've changed the plug and coil packs on that side before, so just a case of taking the same stuff off as i did for those
Lee
Thanks for the quick reply, i've changed the plug and coil packs on that side before, so just a case of taking the same stuff off as i did for those
Lee
#4
Originally Posted by black_scooby
Cheers Magnet,
Thanks for the quick reply, i've changed the plug and coil packs on that side before, so just a case of taking the same stuff off as i did for those
Lee
Thanks for the quick reply, i've changed the plug and coil packs on that side before, so just a case of taking the same stuff off as i did for those
Lee
yep
i also took this piece of metal off that covers the brake pipes, like a heat shield, it was in my way.
you get a bit of oil dripping too.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM