Part No. for K&N Panel Filter for MY00 WRX
#1
Hi Everyone,
Just after the correct Part No. for a MY00 WRX. I was supplied with a K&N filter PN. 33-2031-2 and i was wondering if this is the right one for my car. The gasket seems to be the right size but it is very difficult to shut the lid without the filter moving all around. I am unshure if the filter is in the right spot. Have I been given the right filter?
Thanks
[This message has been edited by Tiger_Aust (edited 07 October 2001).]
Just after the correct Part No. for a MY00 WRX. I was supplied with a K&N filter PN. 33-2031-2 and i was wondering if this is the right one for my car. The gasket seems to be the right size but it is very difficult to shut the lid without the filter moving all around. I am unshure if the filter is in the right spot. Have I been given the right filter?
Thanks
[This message has been edited by Tiger_Aust (edited 07 October 2001).]
#3
T_A,
I have a PDF document from K&N with a list of all the panel filters. I shall email it on to you. I have an MY00 with a K&N panel and it was a bit of an ar$e to fit. Just make sure you have fitted correctly to the bottom ridge, then it should close with a push.
Ian
I have a PDF document from K&N with a list of all the panel filters. I shall email it on to you. I have an MY00 with a K&N panel and it was a bit of an ar$e to fit. Just make sure you have fitted correctly to the bottom ridge, then it should close with a push.
Ian
#5
Thanks Dudes
I took the Airbox lid off completely and fiddled with it and it does fit alright. Just like u said GW2000 an "ar$e" to fit.
I rang K&N distributer and he said i had the right one. But he couldn't find the K&N Filter I found on the internet in his Aust part list.
So he wants the actual Subby part No. so he can do a cross reference himself--i didn't have it with me then. So i will c what he says when i ring him back.
Thank guys
TiGeR
I took the Airbox lid off completely and fiddled with it and it does fit alright. Just like u said GW2000 an "ar$e" to fit.
I rang K&N distributer and he said i had the right one. But he couldn't find the K&N Filter I found on the internet in his Aust part list.
So he wants the actual Subby part No. so he can do a cross reference himself--i didn't have it with me then. So i will c what he says when i ring him back.
Thank guys
TiGeR
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM