Lambdalink that reads NTK wideband 5 wire honda sensor?
#2
Scooby Senior
Join Date: Oct 2000
Location: Zurich, Switzerland
Posts: 3,105
Likes: 0
Received 0 Likes
on
0 Posts
Wont v1.5 of the TechEdge electronics provide this functionaility to the stock lambdalink? With 1.5 you can configure a 0-1v lambda sensor output for the ecu, based on the Honda's input. Depending on how accurately this output follows the Honda's input, there's no longer a need for an A-D input for DeltaDash either....means you can trust the lambda signal from ecu
Did you have any problems with your Techedge? I've only tried with the LED display so far, even free air is reading AFR 10<! I hope it's just the display, will find out tonight.
Did you have any problems with your Techedge? I've only tried with the LED display so far, even free air is reading AFR 10<! I hope it's just the display, will find out tonight.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM