Luke Warm Engine Cut Outs
#1
My STI version 1 has developed a problem where it fails to start when the engine is luke warm. It turns but does not fire. It also cut out after a couple of hundred yards driving today. Has anyone had this problem or have any idea what the cause could be???
#2
Scooby Regular
Join Date: May 1999
Location: Wolverhampton
Posts: 480
Likes: 0
Received 0 Likes
on
0 Posts
When this happened on my car the crank position sensor was at fault. Other people have had the same problem and found a different cure though, such as a temperature sensor.
#3
Scooby Regular
Join Date: Jun 2000
Location: South Wales
Posts: 4,216
Likes: 0
Received 0 Likes
on
0 Posts
Had almost identical problem on my 95 wrx a few months ago- was a faulty camshaft position sensor.
Connect the two diagnostic plugs up under the dash and get a fault code from the check engine light on the dash....cam sensor is code 13 if I recall.
Dave
Connect the two diagnostic plugs up under the dash and get a fault code from the check engine light on the dash....cam sensor is code 13 if I recall.
Dave
#4
Cheers guys. I thought it would be one of the temp sensors. I just hope I can recreate the problem when it's in the garage!! we'll know for sure next week. Does the select monitor always pin point which sensor is at fault? and how much were they to replace?
Thread
Thread Starter
Forum
Replies
Last Post
DogsofWar
Engine Management and ECU Remapping
16
23 September 2015 07:41 PM
alcazar
Non Scooby Related
5
18 September 2015 11:49 PM
Adam Kindness
ScoobyNet General
0
15 September 2015 03:31 PM