What lambda sensor voltage can be considered "safe" on full boost WOT?
#1
Hi all,seem to remember something from John Banks saying 910 to 930 mV is ok,am I correct? Also is this a DC voltage? And I believe you should use a digital voltmeter rather than analogue to measure?
Many Thanks, JohnW.(MY 97 UK with decat exhaust & ITG filter, boost raised to just below fuel cut approx 17 psi peak)
Many Thanks, JohnW.(MY 97 UK with decat exhaust & ITG filter, boost raised to just below fuel cut approx 17 psi peak)
#3
Digital Meter as impedance is usually much higher than analogue so less likely to do harm. Yep its DC.
Hope this helps -
You'll probably see at least 900mv which is over 10% co2 - and more than enough.
Chris
[Edited to state] This is of my DIY AFR - not Autometer (but you probably gathered that from the LEDs)
[Edited by Chris.Palmer - 9/16/2002 12:55:12 PM]
Hope this helps -
You'll probably see at least 900mv which is over 10% co2 - and more than enough.
Chris
[Edited to state] This is of my DIY AFR - not Autometer (but you probably gathered that from the LEDs)
[Edited by Chris.Palmer - 9/16/2002 12:55:12 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM