Lamco boost gauge
#1
Trying to set up my dawes device looking at my boost gauge to find that it ant psi or bar its kg/cm2. How do you covert psi or bar in kg/cm2 i have set it to 1.1kg/cm2 goes very well no fuel cut but just need to know what pressure it is.
#4
cheers Ian W. Is 1.1 kg/cm2 a safe boost pressure to run with these mods full decat zorst,k&n induction will be buying some samco hoses next just to be on the safe side.
#6
Scooby Regular
Join Date: Feb 2001
Location: Greece, previously Syd Australia
Posts: 2,833
Likes: 0
Received 0 Likes
on
0 Posts
Mine under reads. When the engine is switched off the needle doesn't stay right on zero. It stays a tad under. When it was brand new it used to sit smack bang on zero. Others have this probem too.
Cheers,
Wrexy.
Cheers,
Wrexy.
Thread
Thread Starter
Forum
Replies
Last Post