Urgent : Dumb question.
#1
How do I get the carpet up to get at the ecu? there seems to be two large plastic screws (2 pence peice size) that hold the carpet on and I've turned them but the dont seem to be coming off? I've removed the plastic from the left that runs down the door and these are all thats left I'm trying to get a lambda feed for my Dawes AFM. If I cant get this off I'll have to go under the bonnet!
#2
Scooby Regular
You don't need to take the door plastic off. Just remove the little clip on the bottom left of the plastic, then the two plastic screws holding the carpet down.
That's it. They only screw off, so give them a harder pull.
And then it's the 4 bolts holding down the kickplate
The the last two nuts holding down the ECU itself
Stefan
[Edited by ozzy - 7/28/2002 2:00:10 PM]
That's it. They only screw off, so give them a harder pull.
And then it's the 4 bolts holding down the kickplate
The the last two nuts holding down the ECU itself
Stefan
[Edited by ozzy - 7/28/2002 2:00:10 PM]
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
14
25 September 2015 02:33 PM
StueyBII
ScoobyNet General
3
18 September 2015 12:34 PM