Smithygb270

So I have had my gear box refurbished after stripped 3rd gear now iv put it back in I did not touch the clutch itself just removed box and refitted 2 weeks later now my clutch pedal seems to stick either at the floor or halfway down and eaven when I pull it up the car only creeps forward so does not feel like it's engaged in gear properly at all but surely the only thing I could have got wrong is the clutch fork or the release bearing as that is all I have touched
is this something that can cause me these problems b
would love to no if anyone has had this before I take the box out again
ps have bleed the slave and no better thanks for any help it's really appreciated

1509joe

iTrader: (2)

None of that makes sense. If you put it in gear and try and start it does it move then.

Smithygb270

Yes mate it does but like I say if I start the car up then put clutch down select a gear then bring the clutch up it creeps forward almost like a automatic car that is in drive but no.matter how much I apply throttle it just creeps forward also pedal is very heavy creeking and sticking halfway or just stays on the floor I literally have no idea what's happening

1509joe

iTrader: (2)

I'm afraid that's a gearbox off again job unless the clutch fork is jammed up somewhere around the slave cylinder. If you remove the slave cylinder it should move as normal if not its a clutch problem.

stockcar

only 'might' would be if you have filled the slave with air whilst apart and are trying to bleed it on the car as the air will be "trapped" in the nose.....??
is the fork located in the bearing correctly??

1509joe

iTrader: (2)

Has to be jammed up inside Alyn if it won't move correctly when put in gear and started.