Diamond Pro 740SB Monitor
#1
Anyone got one of these monitors?
If so can you help:
When I switch the pc on, the display is never centred properly despite the fact that I have set everything up in the monitor menu. Eventually after about 5 mins, the screen more or less sorts itself out but if can still be a bit out.
I have noticed that when adjusting h-size it goes up in increments of either 2 or 3, so it will go 63, then 65, then 68.
Then on h pos it seems to take 3 presses of the +/- button for it to move onto the next increment.
When the pc is switched on and the display is all shifted over, when I check the settings in the monitor menu, they are as I set them. So it is not forgetting them. However with the h pos being set say on 63, they are actually up to 4 variations on what this 63 means and each variation shifts the screen over.
Have I a faulty monitor?
Can someone confirm what happens on their 740SB monitor.
Thanks.
If so can you help:
When I switch the pc on, the display is never centred properly despite the fact that I have set everything up in the monitor menu. Eventually after about 5 mins, the screen more or less sorts itself out but if can still be a bit out.
I have noticed that when adjusting h-size it goes up in increments of either 2 or 3, so it will go 63, then 65, then 68.
Then on h pos it seems to take 3 presses of the +/- button for it to move onto the next increment.
When the pc is switched on and the display is all shifted over, when I check the settings in the monitor menu, they are as I set them. So it is not forgetting them. However with the h pos being set say on 63, they are actually up to 4 variations on what this 63 means and each variation shifts the screen over.
Have I a faulty monitor?
Can someone confirm what happens on their 740SB monitor.
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM