Symantec VPN Client 8.0
Thread Starter
Joined: May 2000
Posts: 16,980
Likes: 15
From: From far, far away...
Symantec VPN Client 8.0
Anyone use this?
"Appears" to be OK for single dial-ups to attach to the network etc but...
I can authenticate
I can attach
I am shown as connected
(to the gateway)
I cannot ping/browse/etc etc to the citrix server that needs to be accessible nor anything else on that subnet.
W2K w/station through 1603 (12.0 I think)
There is NO problem with MS VPN client.
I have been through Symantec KB and all the correct ports are open with the correct protocols etc. My subnet is not the same.
Anyone any ideas/help?
"Appears" to be OK for single dial-ups to attach to the network etc but...
I can authenticate
I can attach
I am shown as connected
(to the gateway)
I cannot ping/browse/etc etc to the citrix server that needs to be accessible nor anything else on that subnet.
W2K w/station through 1603 (12.0 I think)
There is NO problem with MS VPN client.
I have been through Symantec KB and all the correct ports are open with the correct protocols etc. My subnet is not the same.
Anyone any ideas/help?
Scooby Regular
Joined: Nov 2000
Posts: 2,021
Likes: 1
From: 412 Wheel HP Audi RS4
Chances are it's a routing issue. I would guess and say that the default gateway for your Citrix server is not the VPN terminator device.
To solve this you'll either need to run RIP (or some other Routing Advertising protocol), Add a static route for the remote network (difficult if your using a dial-up) or run DHCP for the VPN session.
To solve this you'll either need to run RIP (or some other Routing Advertising protocol), Add a static route for the remote network (difficult if your using a dial-up) or run DHCP for the VPN session.
Thread
Thread Starter
Forum
Replies
Last Post
Matt Churchill
Computer & Technology Related
2
Jan 7, 2002 08:46 PM