Epson scanner
12 June 2002, 05:39 PM
#1
Scooby Regular
Thread Starter
Join Date: Aug 2002
Location: not forgetting 20,000 posts from last time ;)
Posts: 5,806
Likes: 0
Received 0 Likes
on
0 Posts
A bit of trial and error required I'm afraid. Some things you might try to see if it improves:
Unplug all other USB devices on the same machine.
If it is plugged into a USB hub, try plugging directly into the USB port of the PC.
Install it on another machine
Try a different make/model of scanner on this machine
[Edited by Fig - 12/6/2002 5:45:41 PM]
Unplug all other USB devices on the same machine.
If it is plugged into a USB hub, try plugging directly into the USB port of the PC.
Install it on another machine
Try a different make/model of scanner on this machine
[Edited by Fig - 12/6/2002 5:45:41 PM]
05 December 2002, 11:36 PM
#2
Scooby Regular
iTrader: (1)
Join Date: Aug 2002
Location: Dorset
Posts: 1,616
Likes: 0
Received 0 Likes
on
0 Posts
A friend of mine has just bough an Epson perfection scanner and it is connected to a compay machine. P3 550mhz 398MB of ram
It takes about half an hour to scan ANYTHING it does not matter what settings it has. It has been swapped out for a new one and that does the same. Its USB and other devices have run through those ports without a problem.
Any ideas?
It takes about half an hour to scan ANYTHING it does not matter what settings it has. It has been swapped out for a new one and that does the same. Its USB and other devices have run through those ports without a problem.
Any ideas?
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM